Xerox Synergix 8825 Примечание к выпуску - Страница 15

Просмотреть онлайн или скачать pdf Примечание к выпуску для Программное обеспечение Xerox Synergix 8825. Xerox Synergix 8825 23 страницы. Windows nt 4.0 postscript print driver user guide
Также для Xerox Synergix 8825: Руководство по эксплуатации (48 страниц), Руководство по настройке (20 страниц), Дополнительное руководство (26 страниц), Руководство по программному обеспечению (30 страниц)

8.3 Wide Format Scanner

Scan to net operations on YKE/YKEN/FRX controllers will complete in about the same time as

older controllers, but the scan speed for certain sizes of color and grayscale scans is slower.

When the "Clear Last Image" feature is selected on the Xerox Wide Format Scan System, it may

take a few minutes for a Photo or Color mode scanned document to clear out. After scanning a

document, this feature is accessed by selecting the "C" key on the scanner. It will bring up the

"CLEAR SCANNED IMAGE" screen. Use the "Next" button to select "CLEAR LAST IMAGE", and

then press "ENTER".

Scan a document. Press the Transform key. Select "Recall Last Job". If the Invert feature

(changes dark to light and vice versa) is selected before printing the recalled document, the

document will not be inverted. It will need to be rescanned to get the inverted image.

When performing a scan-to-print operation the scanned image is printed using the current printer

processing defaults including margins. If the image scanned is exactly the width of the paper,

then the processing default margins should be set to zero to prevent the image from being

clipped or placed on a larger sheet of paper.

When using the width detection sensors, if the document is a little bit off-center, this could cause

problems for folding, as the document printed may be square. This is most problematic with A, B,

and C sizes. Documents must be centered when using the sensors for width detection.

The scanner uses the first few inches of a document to determine the background suppression.

If the first few inches of the document being scanned are not representative of the entire

document, either too much or too little of the background will be removed. If this occurs, try

physically turning the document 90 degrees and scan it again. Continue with this until an edge is

found that produces a good scan.

Scaling documents with error diffused shaded areas should be done in a photo mode to produce

the best image quality. Line and normal modes tend to exaggerate the shading dots making

them more visible.

Occasional 50000015 errors have been seen while scanning more than 128 documents on the

6030/6050 system. This happens when an experienced operator gets a significant number of

Page 15