Xerox Wide Format 6050 Руководство по настройке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по настройке для Программное обеспечение Xerox Wide Format 6050. Xerox Wide Format 6050 20 страниц. Wide format twain
Также для Xerox Wide Format 6050: Руководство пользователя (22 страниц), Информация о выпуске (7 страниц), Примечание к выпуску (23 страниц), Примечание к выпуску (8 страниц), Примечание к выпуску (8 страниц), Примечание к выпуску (9 страниц), Руководство по обучению клиентов (50 страниц), Руководство пользователя (36 страниц), Руководство пользователя (48 страниц)

NONE. Your choices will show on the screen, for example: (plt00t). An example queue

name is "plt99" when NONE is selected.

- Press the Update Printer button to set your choices.

NOTE: See the Configure Remote Printer Status Messages at the end of this document.

•

Select CONFIGURATION > NETWORK > TCP/IP.

- Check that the Subnet Mask, IP Address, and Gateway settings are correct. These are

needed so that your workstation will be able to communicate with your FreeFlow Accxes

compliant scanner and printer.

- If the printer is not properly auto negotiating with the network, then set the

Speed/Duplex to something other than "Auto". The other selectable options are "10

Mbps - Half Duplex", "10 Mbps - Full Duplex", 100 Mbps - Half Duplex", and "100 Mbps -

Full Duplex". The Auto setting will properly auto negotiate with a YKE/YKE-N's 1000

Mbps switch.

- Select HELP to access further information from the Help files.

TCP/IP Address Parameters from the Printer

Control Panel

Perform the following steps:

1. At the Printer Control Panel, when the display shows <IDLE>, press ONLINE

2. When the display shows <PAUSED>, press ENTER

3. When the display shows <UTILITIES>, press NEXT

4. When the display shows <SETUP I/O PORTS>, press ENTER.

5. When the display shows <SCSI>, press NEXT until the display shows <ETHERNET

TCP/IP>. Press ENTER.

Once you have access the ETHERNET TCP/IP menu, perform the following steps at the printer

control panel to enable DHCP or RARP/BOOTP:

6. Press the NEXT key until DHCP ENABLE=OFF or RARP/BOOTP ENABLE=OFF is

displayed.

7. Press the ENTER key followed by the NEXT key to change the setting to ON, then press

the ENTER key.

NOTE: Verify that you have DHCP enabled.

8. Press the EXIT key as many times as required to go back to PAUSED mode.

9. Press the ONLINE

10. Wait 60 seconds and cycle the printer power. The printer will reflect the new TCP/IP

address after booting up.

11. Printer a CONFIGURATION & SETTINGS TEST PRINT and save it for future reference.

FreeFlow Accxes Printer System and Web Print Management Tool Setup Guide

key to put the printer back on line. The display will show IDLE.