Xerox Fiery EX4112 Информация о выпуске для клиентов - Страница 2

Просмотреть онлайн или скачать pdf Информация о выпуске для клиентов для Сервер печати Xerox Fiery EX4112. Xerox Fiery EX4112 8 страниц. Version 1.0

Booklet Maker

Booklet Maker documentation

There is no online help specific to Booklet Maker. For information about this feature,

see the Booklet Maker chapter in Print Options on the user documentation CD.

Booklet Maker on Direct queue

When you send a job to the Direct queue, Booklet Maker is not supported, although it is

displayed as enabled. You can send a Booklet Maker job to the Print or Hold queue.

Setting gutter values

The gutter value for a booklet in Booklet Maker cannot be set from the printer driver.

Set the gutter value in Command WorkStation Job Properties.

Selecting a binding method in Mac OS X printer driver

In Booklet Maker, you cannot select Saddle, Perfect, or Nested Saddle binding in the

Mac OS X printer driver, if the printer driver has been installed in Comprehensive

(Constrained) mode. To make these options available, install the Mac OS X printer driver

in Fast (Unconstrained) mode.

Unwanted constraint

If Booklet Maker is enabled, selecting Booklet Fold or Center Stapling in the Finishing

tab of the printer driver with page or print size set to Letter LEF triggers a constraint message.

Select a different print size with valid SEF in Media Tab to resolve constraint.

Align Trays

The Align Trays feature allows you to adjust the placement of text and images on the

page so they are correctly aligned on a sheet of paper. This ensures that both sides of a duplex

sheet have exactly the same alignment. You can also perform tray alignment from the

Fiery EX4112/4127 Control Panel.

To perform tray alignment, you must do the following:

• Log in to the Fiery EX4112/4127 with Administrator privileges and enable tray alignment

in Fiery EX4112/4127 Setup.

• Enable Tray Alignment in the Media area of the Fiery EX4112/4127 printer driver.

• Select the correct paper tray before printing.

For Tray Alignment to work when printing a job, select the tray that you have

OTE

aligned in the Media area before printing. If you later print a job using the auto tray selection,

the alignment does not work.

Page 2