ALDER TAPWARE Vito Bertoni Series Руководство - Страница 2

Просмотреть онлайн или скачать pdf Руководство для Сантехническая продукция ALDER TAPWARE Vito Bertoni Series. ALDER TAPWARE Vito Bertoni Series 2 страницы. Shower / bath diverter

Печатать страницу
INSTALLATION INSTRUCTIONS: SHOWER/BATH DIVERTER
1. Brazed connections should not be made directly onto the mixer, as excessive heat will cause permanent
damage.
2. System must be thoroughly flushed out of foreign material, prior to installation
3. Secure the diverter body onto a suitable mounting plate or noggin in the wall.
4. When facing the mixer, the connections should be as per drawing below:-
5. Check all connections for leaks
6. Mixer body must be installed vertical and square to the wall/tile face, to ensure the cover plate sits flush.
7. To avoid damage to the chrome finish of the diverter, do not remove the protective covers of the push
button assembly and the wall mixer, until installation has been completed.
8. When Rail Shower and Rain Shower are set up as a combination, the rain shower must be the default
setting (i.e. similar as bath set setup). In this instance, the button out is the default for the rain shower.
Note: if the Rail Shower is setup as the default setting, backflow and water cross-contamination could
become an issue.
AFTER TILING
1. Remove the plastic protective cover from the mixer body and the push button assembly.
2. Make sure the back of the wall plate is clean and free of grease.
3. Apply water resistant clear silicone adhesive to the back of the edge of the cover of the wall plate, leaving and
unsealed section at the bottom for drainage.
4. Carefully slide the wall plate onto the diverter body and push it firmly against the wall/tile face.
5. Wipe clean any excess sealant from the chrome surfaces and wall/tile face.
6. Fit handle and push fully down, then tighten grub screw using a 2.5mm Allen key.
7. Fit indicator button
8. Turn on the water supply and check the operation of the diverter
NOTE:-
1.
If the flow rate reduces on the shower or bath outlets, check the aerator filter to ensure debris is not blocking the flow
A pressure limiting device must be fitted, if pressure exceeds 500kPa -
2.
Hot and cold water inlet pressures should be equal
3.
FREECALL: 1800 800 919
For all servicing needs, please contact CUSTOMER SERVICE on:
PHONE: 08 93094688
www.aldertapware.com.au
Refer AS/NZS 3500.1:2003 (Clause 3.34)
FAX: 08 9409 6589
www.vitobertoni.com.au
35mm Cartridge
V02 140210