CALI ALS600T-AD-AA-BM Series Руководство по установке

Просмотреть онлайн или скачать pdf Руководство по установке для Стойки и подставки CALI ALS600T-AD-AA-BM Series. CALI ALS600T-AD-AA-BM Series 2 страницы.
Также для CALI ALS600T-AD-AA-BM Series: Руководство по установке (11 страниц)

Печатать страницу
Perspective
1.
Measure area where ALS600T-AD will be installed.
Use a chalk line to ensure a straight installation.
20'
2.
Determine number of mounting arms needed. Use a minimum of two mounting
arms per fixture. Mount arms 6" from center of mounting plate to end of fixture.
Refer to Spacing Diagram on page 2.
3.
Mark location where mounting arms will be installed. Screw arms to desired
surface using proper drill bit for surface and screw size.
2.00"
2.00"
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
2018.09.20 Rev 0
2.00"
End View
2.00"
2.00"
4.
Snap fixture into mounting bracket and install set screws on both sides.
Ensure fixture is secured in place, and spacing is accurate according to the
spacing diagram on page 2.
Chalk line
2.96"
2.00"
X" (Specify Length)
5.
Loosen set screw until the mounting bracket can move freely. Turn the mounting
bracket until desired angle is achieved, then mate the locking bump with locking
hole. Refer to the angle increments diagram on page 2. Tighten set screw until
mounting bracket is secured in place.
4.61"
X" (Specify Length)
ALS600T-AD-AA-BM-X
3.23"
X" (Specify Length)
2.61"
X" (Specify Length)
3.11"
X" (Specify Length)
4.13"
Set screw
X" (Specify Length)
Set screw
Mounting bracket
Locking hole
Locking bump
This document is issued in strict confidence on condition that it
is not used as a basis for manufacture or sale and is not copied,
reprinted, or disclosed to a third party either wholly or in part
without the prior written consent of California Accent Lighting, Inc.
Top View
PUSH
PUSH
2.00"
X" (Specify Length)
2.00"
6.
If applicable, connect disconnects between fixtures. Push and twist cap to lock
connector. Use a shrink tube to seal connector.
X" (Specify Length)
Shrink tube
2.00"
Apply heat
Assembled End View
2.00"
X" (Specify Length)
X" (Specify Length)
2.00"
X" (Specify Length)
2.00"
Add 0.93" to overall height for fixtures with louver installed
X" (Specify Length)
alumLEDs
Manufactured in the U.S.A.
Page 1 of 2
INSTALLATION
3.23"
1.5"
1.5"
2.61"
2.96"
3.11"
4.61"
4.13"
™