Yamaha HTR-5230RDS Руководство пользователя - Страница 12
Просмотреть онлайн или скачать pdf Руководство пользователя для Приемник Yamaha HTR-5230RDS. Yamaha HTR-5230RDS 50 страниц. Natural sound av receiver
Печатать страницуCONNECTIONS
Connecting the Antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal
strength. However, a properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the quality.
Connect each antenna correctly to the designated terminals.
Indoor FM antenna (included)
Outdoor FM antenna
75-ohm/300-ohm antenna
adapter (included for U.K.
model)
75-ohm coaxial cable
75-ohm/300-ohm antenna
adapter (included for U.K.
model)
300-ohm feeder
Connecting a coaxial cable to the included 75-ohm/300-ohm antenna
adapter (U.K. model only)
1
Cover
3
Lead wire
4
Clamp with
pliers.
10
Indoor FM
antenna
2
11 (7/16)
Unit: mm
8 (5/16)
6 (1/14)
(inch)
5
Clamp with
pliers.
Insert the wire
into the slot.
Firmly insert the connector into the FM ANT terminal. The
indoor FM antenna is only a simple antenna. For reception
with better sound quality, installing the outdoor FM antenna
(commercially available) is recommended.
Note
• Do not connect an outdoor FM antenna and the indoor FM
antenna at the same time.
You may be unable to obtain good FM radio reception
depending on your local conditions (distance from the
broadcasting station, interposing buildings and
mountains, etc.). Consult your dealer or authorized service
center and be sure to install an antenna that suits your local
conditions.
Install the outdoor FM antenna (commercially available) in
a high place as far away from any roads as possible to avoid
being affected by automobile ignition noise.
1
Open the cover of the included 75-ohm/
300-ohm antenna adapter.
2
Cut the external sleeve of the 75-ohm coaxial
cable and prepare it for connection.
3
Cut the lead wire and remove it.
4
Insert the cable wire into the slot, and clamp it
with pliers.
5
Snap the cover into place.