Yamaha CX-1000 Руководство пользователя - Страница 13

Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Yamaha CX-1000. Yamaha CX-1000 20 страниц. Natural sound stereo control amplifier
Также для Yamaha CX-1000: Руководство пользователя (21 страниц), Руководство пользователя (20 страниц), Руководство по эксплуатации (38 страниц)

- For audio-only sources, or where the video source is the same as the

audio source:

1. The component(s) you wish to listen to or watch should be turned

on before powering up the CX-1000.

2. Making sure that the volume control is set to minimum level, press

the CX-1000 POWER switch, then turn on your power amplifier.

4. Adjust the VOLUME, LOUDNESS, BALANCE and tone controls as

- desired.

You can now watch the video source while listening to the selected

audio source.

NOTE:

It is not possible to watch a video source (such as VCR1) while

listening to the audio signal of a different video source (such as

CDV1).

When listening at low volume levels, adjust LOUDNESS (if required)

by first setting this knob to the FLAT position and the VOLUME control

to the maximum desired listening level. Then turn the LOUDNESS

knob counterclockwise to reduce overall volume while retaining a `

natural sound.

LOUUNESS

FLAT

Set loudness to the Flat

position and increase the

Volume to loudest level

desired.

VOLUME

Turn loudness control

knob counterciockwise

to reduce the volume.

Audio sources or the sound-track of video sources can be recorded

either with a connected DAT/cassette deck or a VCR.

Since the source signal selected with the REC OUT selector is always

present at the rear panel TAPE1/DAT1

(or TAPE2/DAT2, TAPES, DI-

GITAL DAT1, DAT2) OUT jacks, audio recording is possible simul-

taneously with all connected decks (cassette recorder(s), DAT

deck(s), VCR(s) etc.). To record from VCR/TAPE to DAT or vice versa,

see "Dubbing" below.