Yamaha Electone HS-7 Руководство пользователя - Страница 6

Печатать страницу

Yamaha Electone HS-7 Руководство пользователя

NOTICE

To avoid the possibility of malfunction/ damage to the

product, damage to data, or damage to other property,

follow the notices below.

 Handling and Maintenance

• Do not expose the device to excessive dust or vibration,

or extreme cold or heat (such as in direct sunlight, near

a heater, or in a car during the day), in order to prevent

the possibility of panel disfiguration, unstable operation,

or damage to the internal components.

• Do not place vinyl, plastic or rubber objects on the

device, since this might discolor the panel.

• When cleaning the device, use a dry and soft cloth. Do

not use paint thinners, solvents, cleaning fluids, or

chemical-impregnated wiping cloths.

• Condensation can occur in the device due to rapid,

drastic changes in ambient temperature—when the

device is moved from one location to another, or air

conditioning is turned on or off, for example. Using the

device while condensation is present can cause

damage. If there is reason to believe that condensation

might have occurred, leave the device for several hours

without turning on the power until the condensation has

completely dried out.

• During extreme changes in temperature or humidity,

condensation may occur and water may collect on the

surface of the device. If water is left, the wooden parts

may absorb the water and be damaged. Make sure to

wipe any water off immediately with a soft cloth.

• Interference From Cell Phones

Using a cell phone near the speaker system can induce

noise. If this occurs, move the cell phone further away

from the speaker system.

• Air blowing out of the bass reflex ports is normal, and

often occurs when the speaker is handling program

material with heavy bass content.

• Always turn the power off when the device is not in use.

• Avoid touching or allowing objects to come in contact

with the speaker diaphragms.

• These speakers should be used vertically, not laid on

their side.

 Connectors

• XLR-type connectors are wired as follows (IEC60268

standard): pin 1: ground, pin 2: hot (+), and pin 3: cold

(-).

HS8/HS7/HS5/HS8S Owner's Manual

Information

 About this manual

• The illustrations as shown in this manual are for

instructional purposes only, and may appear somewhat

different from those on your device.

• Steinberg and Cubase are registered trademarks of

Steinberg Media Technologies GmbH.

• The company names and product names in this manual

are the trademarks or registered trademarks of their

respective companies.