ecopoint EBT1550W48W840-G2 Инструкции к продуктам - Страница 2
Просмотреть онлайн или скачать pdf Инструкции к продуктам для Стойки и подставки ecopoint EBT1550W48W840-G2. ecopoint EBT1550W48W840-G2 2 страницы. Surface mount batten gen 2
Печатать страницуSTANDARD SPECIFICATIONS
Power Factor
≥ 0.95 (230V)
Electrical Input
220-240 V / 50-60 Hz
Operating Temperatures
- 20 to +40 deg. C
Construction
PVC mount, alum. body, PC diffuser
Ingress Protection
IP20
Impact Protection
N/A
Warranty
5 years
STANDARD MODELS
Product Code
EBT1550W24W840-G2
1550 x 100 x 58 mm
EBT1550W48W840-G2
1550 x 100 x 58 mm
INSTALLATION NOTES:
The following notes must be considered prior to installation of the product:
The luminaire has been designed to operate in accordance with the specifi-
cations listed above; please especially note the electrical input, operating
temperature and ingress/impact protection specifications and ensure that
the luminaire will only be operated within a suitable environment.
The luminaire must be securely fixed to a suitable surface or structure which
is able to bear the luminaire weight and provide the necessary restraint un-
der seismic loading according to NZS 4219.
The luminaire must be installed such that adequate space is available for
ventilation to prevent overheating.
Exposure to UV (i.e. direct sunlight) over an extended period may cause dis-
colouration of the diffuser and/or luminaire body.
The luminaire is not suitable for marine environments nor for hazardous or
corrosive environments.
Size
Power
Nominal Flux
26.0 W
3,380 lm
45.1 W
5,800 lm
Remove luminaire from packaging, detach body from the light engine
(leaving restraint cables hanging), draw power feed cable through rear
of body, and fix the body to the mounting surface.
Attach light engine to the restraint cables, then connect power feed
cable to the fused terminal block on the rear of the light engine.
Confirm electrical connections into the terminal block are secure, then
raise the light engine back up to the level of the body and push-fit until
a positive 'click' sounds indicates that it has attached correctly.
Connect power to mains supply and test the luminaire for correct oper-
ation and switching.