Clark-Reliance Jerguson 360 Series Руководство по установке, эксплуатации и техническому обслуживанию - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке, эксплуатации и техническому обслуживанию для Блок управления Clark-Reliance Jerguson 360 Series. Clark-Reliance Jerguson 360 Series 12 страниц. Safety ballcheck valves

Печатать страницу

Jerguson

360 Series

8. Recommended Commissioning Procedure

1. If the vessel does not contain any process fluid, move the top then bottom valve to the run position.

As long as liquid slowly fills the gage, the ballcheck will not engage. If there is concern over the rate

at which fluid will enter the gage, then follow the remaining steps in this procedure.

2. When there is already liquid present in the vessel open the top valve to the bypass position. It is best

practice when commissioning any level gage to open the top valve first. This allows the pressure of

the vessel to equalize with the gage.

3. Open the bottom valve to the bypass position. This will allow liquid to flow from the vessel through

the valve and into the gage. Note: While the valve is in bypass mode the ballcheck cannot seat.

4. Wait until the fluid stops rising.

5. Operate the handle on the top valve and move the arrow to the run position.

6. Operate the handle on the bottom valve and move the arrow to the run position. The gage is now

ready for normal operation. In the event of a catastrophic failure the ballchecks will seat isolating the

gage from service.

http://www.Jerguson.com/360-series

Visit

commissioning a glass level gage equipped with the 360 series safety ballcheck valves.

9. Maintenance

16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828

for a video demonstration of the proper procedure for

Rebuild Kit Exploded View (Part# S25189)

www.Jerguson.com ● [email protected]

IOM J500.36

2017.10