Directed Xpresskit DBALL2 Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильные аксессуары Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 10 страниц. Ford5 remote start ready (rsr) installation
Также для Directed Xpresskit DBALL2: Руководство по установке (12 страниц), Руководство по установке (19 страниц), Руководство по установке (18 страниц), Руководство (14 страниц), Руководство по установке (13 страниц), Руководство по установке (14 страниц), Руководство по установке (19 страниц), Руководство по установке (16 страниц), Руководство по установке (20 страниц), Руководство по установке (15 страниц), Руководство по установке и краткому руководству (16 страниц), Руководство по установке (18 страниц), Руководство по установке (16 страниц), Руководство по установке (18 страниц), Руководство по установке (16 страниц), Руководство (19 страниц), Руководство по установке (11 страниц)

Печатать страницу
Directed Xpresskit DBALL2 Руководство по установке
Platform: DBALL2
Firmware: REN11

LED Diagnostics and Troubleshooting

LED
Status
Module Programming
Solid Red.
Solid
Solid Red for 30 seconds,
Solid x30 secs
x2
then flashes 2x
Flashes
Solid Red for 30 seconds,
Solid x30 secs
x3
then flashes 3x
Flashes
Flashes Green
Flashes
continuously.
x3
Solid
secs
Solid Green for 3 seconds.
Active Ground While Running
Flashes Green
Flashes
continuously.
Off.
Off
Inactive Ground While Running
Flashes Green 1x
Flashes x1
Flashes Green 2x
Flashes x2
Flashes Green 4x
Flashes x4
Description
Waiting for the vehicle to be
started.
HS CAN not detected.
Invalid CAN network.
Ignition has been successfully
detected.
Module has been successfully
programmed.
Ground out (GWR) is active.
N/A.
Lock command has been
received.
Unlock command has been
received.
AUX 1 command has been
received.
Troubleshooting
Make sure that all the connections are correct (see
install sheet) and turn the ignition ON to begin the
programming sequence.
The CAN wires may be incorrectly connected. Refer to
the wiring diagram to make the right connections.
The CAN bus was detected but the ignition on CAN
message is not detected. Check if the firmware from
unit is correct.
N/A.
N/A.
N/A.
The Ground While Running (status) wire is incorrectly
connected. Refer to the wiring diagram to make the right
connections.
If it does not flash, the bypass module did not receive the
signal. Verify the connections between the bypass and
the remote starter module.
If it does not flash, the bypass module did not receive the
signal. Verify the connections between the bypass and
the remote starter module.
If it does not flash, the bypass module did not receive the
signal. Verify the connections between the bypass and
the remote starter module.
Rev.: 20230129
Page 8
© 2022 Directed. All rights reserved.