ACOPOWER KIT-HYS200MB Руководство - Страница 9
Просмотреть онлайн или скачать pdf Руководство для Солнечная панель ACOPOWER KIT-HYS200MB. ACOPOWER KIT-HYS200MB 12 страниц.
Печатать страницуBattery Type
①Sealed (Default)
NOTE: Please refer to the battery voltage parameters table for the different
battery type.
Troubleshooting
Faults
The
LCD
is
during daytime when
sunshine falls on PV
modules properly
Wire connection is
correct,
LCD
not
display
Interface
blink
Interface
blink
Interface
blink
Interface
blink
www.ACOPower.com
Possible reasons
off
PV
disconnection
1. Battery voltage is
lower than 9V
2. PV voltage is less
than battery voltage
Battery over voltage
Battery
over discharged
Battery Overheating
Over load or Short
circuit
KIT-HYS200MB
②Gel
③Flooded
Troubleshooting
array
Confirm that PV wire connections
are correct and tight
1. Please check the voltage of
battery. At least 9V voltage to
activate the controller
2. Check the PV input voltage
which should be higher than
battery's
Check if the battery voltage is
higher than OVD point (over
voltage disconnect voltage), and
disconnect the PV.
When the
restored to or above LVR point
(low voltage reconnect voltage),
the load will recover
The controller will automatically
turn the system off. But while the
temperature decline to be below
50 ºC, the controller will resume.
Please reduce the number of
electric
equipments
carefully loads connection.
4120 Valley Blvd Walnut, CA 91789, USA
battery
voltage
is
or
check
Power Your Green Life!
+1-626-737 1140