Clarke 7614020 Руководство по эксплуатации и техническому обслуживанию - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Электроинструмент Clarke 7614020. Clarke 7614020 17 страниц. 10 tonne hydraulic bench press
Печатать страницу
The mandrel can then be pushed
into the adaptor where the built-in
spring clip will hold it in place.
Store the mandrels in their positions
on the mounting bracket when not in
use.
OPERATION
WARNING: FAILURE TO HEED THE WARNINGS ON PAGE 3 MAY RESULT IN
DAMAGE TO THE EQUIPMENT, OR FAILURE RESULTING IN PROPERTY
DAMAGE OR PERSONAL INJURY.
1. Place the workpiece on the bed. It must be completely stable and
supported by packing or shims where required. 'Heel' blocks (arbor plates)
are supplied, which locate on the bed. Place the workpiece on a
combination of these to give it stability.
CAUTION: DO NOT POINT LOAD THESE ACCESSORIES AS THEY ARE NOT
DESIGNED TO TAKE THE FULL FORCE OF THE RAM IN ONE SPOT. ENSURE
THEY ARE ADEQUATELY SUPPORTED.
NOTE: Any packing pieces or shims used MUST be capable of
withstanding the pressure that will be brought to bear, and MUST
be of sufficient size with sufficient surface area, so as to avoid the
possibility of slipping or springing out. Mating surfaces MUST be
horizontal so that the force being exerted will NOT be at an angle.
2. Close the release valve by turning
it clockwise until tightly closed.
3. Pump the handle to bring the ram
very lightly into contact with the
workpiece.
4. Manoeuvre the workpiece so that
the desired point of contact is
directly beneath the centre of the
ram.
5. When satisfied that the workpiece
is correctly aligned and is completely stable in that position, slowly pump
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8