Clarke Contractor CON750 Инструкции по эксплуатации и техническому обслуживанию - Страница 6
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Электроинструмент Clarke Contractor CON750. Clarke Contractor CON750 20 страниц. Contractor jigsaw
Также для Clarke Contractor CON750: Руководство по эксплуатации и техническому обслуживанию (17 страниц)
Печатать страницу
JIGSAW SAFETY INSTRUCTIONS
1. Only use the jigsaw in the manner and for the functions described in these
instructions.
2. Using the correct blade. Use the appropriate saw blade for the material
being cut. Different blades are available from your Clarke dealer.
3. Use of the mains cable. Keep the mains cable well away from the
machine and ensure an adequate electrical supply is close at hand so
that the operation is not restricted by the length of the cable.
4. Working on the bench. Allow sufficient clearance beneath the work to
ensure the blade does not come into contact with the floor, table etc.
5. Switching off. Never place the saw on a table or bench if it has not
completely stopped. The saw blade will continue to reciprocate for a
short time after the trigger has been released to stop the saw.
6. Cutting of pipes. Do not cut hollow pipe and do not cut material above
the specified thickness.
7. Cutting into walls. Do not cut through walls or cavities before checking for
hidden electrical wires or water pipes etc.
8. Finishing cutting. Do not remove tool from work until the blade has
completely stopped. Do not touch the blade immediately after use, allow
time for it to cool.
9. Use outdoor extension leads. If working outdoors, always use an approved
cable extension suitable for the power rating of this tool (see
specifications), the conductor size should also be at least the same size as
that on the machine, or larger. When using a cable reel, always unwind
the cable completely. We strongly recommend that this machine is
connected to the mains supply via a Residual Current Device (RCD).
10. Cutting sheet materials. Do not cut work less than at least twice the pitch
of the saw blade. i.e. at least two teeth must be in contact with the work
at all times.
11. Always hold the saw by its insulated handle. The saws metal parts may
become conductive if the blade should come into contact with the
mains cable.
12. Beware of foreign objects. When cutting pre-used wood, ensure all nails
have been removed beforehand. Nails will damage the wood saw blade.
13. Cooling agents. When cutting metals, always use a cooling agent i.e.
cutting/soluble oil.
14. Changing the blade. Be careful during adjustment of the machine to
prevent trapping the fingers between a moving blade and fixed parts of
the machine. Ensure the blade is fully tightened before use.
Please keep these instructions in a safe place for future reference.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
6