Clarke CPSB200 Руководство по эксплуатации и техническому обслуживанию - Страница 10

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Электроинструмент Clarke CPSB200. Clarke CPSB200 20 страниц. Pressurised sandblaster

Печатать страницу

Start the compressor and open

the air supply valve, see Fig 9.

• The tank will start to pressurise.

Test the safety valve by pulling up

on the valve as shown in Fig 10.

• Air will hiss out when the valve is

pulled.

Open the throttle valve, Fig 11.

5. Check for leaks at the filler cap

and along all hoses and fittings as

the system pressurises. If leaks are

observed, release the pressure

from the tank and repair leaks

immediately.

6. Press and hold the trigger until air

is flowing through it.

With the trigger being held open,

slowly open the abrasive control

valve as shown in Fig 12 until

abrasive material begins to flow

out of the trigger.

8. Adjust the abrasive control valve

until the desired amount of

abrasive material is flowing

through the trigger,

• Choose a larger nozzle for a

broader spray pattern. Choose a smaller nozzle for more focused

spray.

• Adjust air pressure with the throttle valve. Adjust abrasive flow with

abrasive control valve,

• Watch for abrasive clogging. if this happens, release pressure from

the tank if necessary and replace the abrasive with drier or cleaner

abrasive.

Fig 10

Fig 11

Fig 9

Fig 12