Zanussi ZFD 50/17 RAL Буклет с инструкциями - Страница 6
Просмотреть онлайн или скачать pdf Буклет с инструкциями для Холодильник Zanussi ZFD 50/17 RAL. Zanussi ZFD 50/17 RAL 19 страниц. Zanussi owners manual compact refrigerator freezer zfd 50/17 r, zfd 50/17 ral
Печатать страницу
Warning
IF YOU ARE DISCARDING AN OLD APPLIANCE
THAT HAS A LOCK OR CATCH ON THE DOOR,
YOU MUST ENSURE THAT IT IS MADE
UNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.
Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
on "Door reversal directions" paragraph.
Positioning
This appliance is designed to operate in ambient
temperatures between 10 C (50 F) and 32 C (90 F). It
should be located in a dry atmosphere, out of direct
sunlight and away from extreme temperature e.g. not
next to a cooker or other sources of direct heat, or in a
very cold room e.g. an outhouse, where the
temperatures may fall below 10 C (50 F). If these
temperatures are exceeded i.e. colder or warmer, then
the appliance may not operate correctly.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There must
also be at least 100 mm (4") distance between the top
of the cabinet and any overhanging kitchen furniture
(Fig. 1-A). Ideally, the appliance should not be
positioned beneath overhanging furniture (Fig. 1-B).
There should also be a gap of 25 mm either side of the
appliance. Do not obstruct the space underneath. The
back of the cabinet may be placed close to the wall
but must not touch it. DO NOT install in places with
restricted ventilation.
Adjust the level of the appliance by screwing out the
adjustable foot, or feet, at the bottom of the cabinet
using your fingers or a spanner (see Fig. 2).
Rear spacers
The plastic bag containing all relevant documentation
also contains two spacers to be fitted into special
holes in the back of the appliance.
Fit the spacers into the holes, taking care to ensure
that the arrow (A) is positioned as shown in Fig. 2a.
Then turn them through 45 (arrow (A) vertical) until
they lock into place.
6
INSTALLATION
A
NP005
D200
45°
D060
Fig. 1
B
Fig. 2
Fig. 2a
A
GB