Zanussi ZFD 50/33 R Буклет с инструкциями - Страница 5

Просмотреть онлайн или скачать pdf Буклет с инструкциями для Холодильник Zanussi ZFD 50/33 R. Zanussi ZFD 50/33 R 16 страниц. Zanussi fridge-freezer instruction booklet model number: zfd 50/33 r

Печатать страницу

Warning

IF YOU ARE DISCARDING AN OLD

APPLIANCE THAT HAS A LOCK OR CATCH

ON THE DOOR, YOU MUST ENSURE THAT IT

IS MADE UNUSABLE TO PREVENT YOUNG

CHILDREN BEING TRAPPED INSIDE.

Depending upon the position which you choose

for your appliance, you may wish to reverse the

way in which the door opens. To do this, refer to

instructions on "Door reversal directions"

paragraph.

Positioning

This appliance is designed to operate in

ambient temperatures between 10°C (50°F) and

32°C (90°F). It should be located in a dry

atmosphere, out of direct sunlight and away

from extreme temperature e.g. not next to a

cooker or other sources of direct heat, or in a

very cold room e.g. an outhouse, where the

temperatures may fall below 10°C (50°F). If

these temperatures are exceeded i.e. colder or

warmer, then the appliance may not operate

correctly.

You should also ensure that air can circulate

freely around the back and the top of the

cabine". There must also be at least 100 mm

(4") distance between the top of the cabinet and

any overhanging kitchen furniture (Fig. 1-A).

Ideally, the appliance should not be positioned

beneath overhanging furniture (Fig. 1-B).

There should also be a gap of 25 mm either

side of the appliance. Do not obstruct the space

underneath. The back of the cabinet may be

placed close to the wall but must not touch it.

DO NOT install in places with restricted

ventilation.

Adjust the level of the appliance by screwing

out the adjustable foot, or feet, at the bottom of

the cabinet using your fingers or a spanner (see

Fig. 2).

Rear spacers

The plastic bag containing all relevant

documentation also contains two spacers to be

fitted into special holes in the back of the

appliance. Fit the spacers into the holes, taking

care to ensure that the arrow (A) is positioned

as shown in Fig. 3. Then turn them through 45°

(arrow (A) vertical) until they lock into place.

INSTALLATION

NP005

D200

PR60

Fig. 1

Fig. 2

Fig. 3