Zanussi ZRB324WO1 Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Холодильник Zanussi ZRB324WO1. Zanussi ZRB324WO1 30 страниц.
Печатать страницу
How to save energy
•
Avoid pulling the appliance in a sunny place and
near anything that gives off heat.
•
Be sure that the condenser and the compressor are
well ventilated. Do not cover the sections where
ventilation is.
•
Wrap products in tightly closing dishes or cling film
to avoid building up unnecessary frost.
•
Do not leave the door open longer than necessary
and avoid unnecessary openings.
•
Put warm foods into the appliance when they are at
room temperature.
•
Keep the condenser clean.
The appliance and environment
This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant circuit
or insulation materials. The appliance shall not be
discarded together with the urban refuse and rubbish.
Avoid damaging the cooling unit, especially at the rear
near the heat exchanger. Information on your local
disposal sites may be obtained from your municipal
authorities.
The materials used on this appliance marked with the
symbol are recyclable.
Maintenance
Defrosting
Bleeding part of the moisture of cooling chambers in
form of frost and ice goes with the operation of the
appliance.
Thick frost and ice has an insulating effect, so it reduces
cooling efficiency as the temperature increases in the
cooling chambers and they need more energy.
At this type of appliance defrosting the cooling plate
of the refrigerator is automatic without any external
intervention. The thermostatic control interrupts the
operation of compressor at regular intervals for more
or less time during this cooling is interrupted the
temperature of the cooling plate goes above 0 °C due to
interior heating load of the compartment, so defrosting
occurs. When the surface temperature of the cooling
plate has reached +3 - +4 °C the thermostatic control
restarts operation of the system.
Melting water flows through defrost water outlet leaded
through the back into the evaporative tray maintained on
the top of compressor and evaporates due to its warmth.
Check and clean the outlet of melting water
coming during defrosting regularly
–
a label inside the appliance warns you
for this. If it is clogged the melting water
gathered can cause earlier failure as it can
go to the insulating of the appliance
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure above.
The pipe scraper has to be stored in the outlet.
The most typical case of clogging up in the melting
water outlet when you put food wrapped in some paper
into the appliance and this paper contacts back plate of
the refrigerator and freezes to it. If you remove the food
right at this moment the paper will tear and it can cause
clogging up in the outlet by gelling into it.
So you are asked to be careful because of the
above when placing foods wrapped in paper into the
appliance. In case of increased demand e.g. during heat
waves, the refrigerator temporarily happens to operate
constantly. During this the automatic defrosting is
ineffective.
7
GB