Zanussi BM 96 EX Буклет с инструкциями - Страница 13
Просмотреть онлайн или скачать pdf Буклет с инструкциями для Печь Zanussi BM 96 EX. Zanussi BM 96 EX 16 страниц. Built-in ovens bm96; bms841
Также для Zanussi BM 96 EX: Буклет с инструкциями (21 страниц), Буклет с инструкциями (16 страниц)
The Oven Door
Before cleaning the oven door, we recommend you to
remove it from the oven.
Proceed as follows:
a) open the oven door completely;
b) find the hinges linking the door to the oven;
c) unlock and turn the small levers located on the two
hinges;
d) handle the door by its left- and right-hand sides,
then slowly turn it towards the oven until it is half-
closed;
e) gently pull the oven door off its site;
f) place it on a steady plan.
Clean the oven door glass with warm water and a softh
cloth only.
Once the cleaning is carried out, refit the oven door,
following the procedure in reverse.
For the BMS 841 X and BM 96 EX models, we
recommend to clean the outer surface of the oven door
with a wet sponge, and then carefully wipe it dry with a soft
cloth. Do not use any abrasive cleaning product, such as
steel wool or acids, as they could damage the stainless
steel surface.
Follow the same procedure for the control panel.
Grease Filter
To prevent a build-up of fats on the fan impellor, the grease
filter must be fitted by clipping it over the vents in the back
panel.
To clean the grease filter
When the oven has cooled down, remove the filter by
pushing the protruding tongue on the filter upward, and
wash carefully.
The grease filter should be cleaned after every use. The
filter may be washed in a dishwasher on a 65°C wash. If
the filter is heavily soiled, place the filter in a saucepan of
water with approximately 1 teaspoon of automatic washing
powder or dishwasher powder. Bring to the boil and leave
to soak for approximately 30 minutes or longer depending
on the degree of soiling. Ensure the solution does not boil
over as it could mark your hob.
Rinse filter in clear water and dry.
Remember to refit the filter before using the oven again.
Replacing the Oven Light
If the oven bulb needs replacing, it must comply with the
following specifications:
- Electric power: 25W,
- Electric rate: 230 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Service Centre.
To replace the faulty bulb:
1. Ensure the oven is isolated from the electrical supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover.
5. Restore the electrical supply.
All manuals and user guides at all-guides.com
FO 0287
13