Clarke X-Pro CAT213 Инструкции по эксплуатации и техническому обслуживанию - Страница 11
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Электроинструмент Clarke X-Pro CAT213. Clarke X-Pro CAT213 17 страниц. Air nibbler
Печатать страницу
MAINTENANCE
WARNING: MAKE SURE THAT THE TOOL IS DISCONNECTED FROM THE AIR
SUPPLY BEFORE PERFORMING ANY CLEANING OR MAINTENANCE.
Please note that factors other than the tools condition may effect its operation
and efficiency. These include reduced compressor output, excessive drain on
the airline, moisture or restrictions in the air-line, or the use of connectors of
incorrect size or poor condition which will reduce air supply.
DAILY
1. Before use, drain water from the air-line and compressor.
2. Lubricate the tool daily for
optimum performance. Use a high
quality airline oil either via a
lubricator in the air supply system
or by placing a few drops into the
tool immediately before use. This
should be carried out regardless of
whether or not an in-line lubricator
is used.
3. Oil can be added via the
lubrication cover on top of the
nibbler. It is screwed on finger tight.
CLEANING & OVERHAUL
1. Keep the tool clean and free from debris.
2. If the tool becomes sluggish and the air supply is of good quality, it may be
necessary to replace worn or damaged parts.
3. Grit or gum deposits in the mechanism may eventually reduce efficiency.
This condition can be corrected by cleaning the air inlet filter and flushing
out the tool with gum solvent oil or an equal mixture of SAE No10 oil and
paraffin.
4. Failing this, the tool should be disassembled, thoroughly cleaned, dried
and reassembled. You may prefer to take the tool to your CLARKE dealer if
internal maintenance is required.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11