Zanussi FL 908 Буклет с инструкциями - Страница 21

Просмотреть онлайн или скачать pdf Буклет с инструкциями для Стиральная машина Zanussi FL 908. Zanussi FL 908 23 страницы. Front-loading washing machine

Печатать страницу

Something not working?

Problems which you can resolve yourself, before calling the After Sales Service.

During machine operation it is possible that the END (FIN) light starts to flash:

4 flashes= the door has not been closed

2 flashes= the machine does not empty

1 flash= the machine does not fill.

Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after all

checks, the problem persists, contact your local Service Centre.

Problem

• The machine does not start up:

• The machine does not fill:

• The machine fills then empties

immediately:

• The machine does not empty and/or

does not spin:

• There is water on the floor:

• Unsatisfactory washing results:

Possible cause

• The door is not firmly closed.

• The machine is not plugged in or there is no power

at the socket.

• The main fuse has blown.

• The programme selector dial is not positioned

correctly and the START/PAUSE button has not

been depressed.

• The DELAY START option has been selected.

• The water tap is closed.

• The inlet hose is squashed or kinked.

• The filter in the inlet hose is blocked.

• The door is not properly closed.

• The end of the drain hose is too low. Refer to

relevant paragraph in "water drainage" section.

• The drain hose is squashed or kinked.

• The RINSE HOLD option has been selected.

• The drain pump is clogged.

• The laundry is not evenly distributed in the drum.

• Too much detergent or unsuitable detergent

(creates too much foam) has been used.

• Check whether there are any leaks from one of the

inlet hose fittings. It is not always easy to see this

as the water runs down the hose; check to see if it

is damp.

• The drain hose is damaged.

• The cap on the emergency emptying hose has not

been replaced after cleaning the filter.

• The pump has not been fully screwed in after

cleaning.

• Too little or too much detergent has been used.

• An unsuitable detergent has been used.

• Stubborn stains have not been treated prior to

washing.

• The correct programme/temperature was not

selected.

• Excessive laundry load.