Zanussi ZDT8453 Книга инструкций - Страница 5

Просмотреть онлайн или скачать pdf Книга инструкций для Посудомоечная машина Zanussi ZDT8453. Zanussi ZDT8453 21 страница.

Печатать страницу

Water outlet hose connection

The end of the drain hose can be connected in the following

ways:

1. To the sink outlet spigot, securing it to the underside of the

work surface. This will prevent waste water from the sink

running into the machine.

2. Hooked over the edge of the sink using the special curved

plastic guide (if provided with the machine).

3. To a stand pipe provided with vent-hole, minimum internal

diameter 4 cm.

The waste connection must be at a height of between 30 cm

(minimum) and 100 cm (maximum) from the bottom of the

dishwasher.

The drain hose can face either to the right or left of the

dishwasher

Ensure the hose is not bent or squashed as this could prevent

or slow down the discharge of water.

The sink plug must not be in place when the machine is

draining as this could cause the water to siphon back into the

machine.

If you use a drain hose extension it must be no longer than 2

metres and its internal diameter must be no smaller than the

diameter of the hose provided.

CS18

Likewise the internal diameter of the couplings used for

connections to the waste outlet must be no smaller than the

diameter of the hose provided.

Attention!

Our appliances are supplied with a security device to protect

against the return of dirty water back into the machine.

If the spigot of your sink has a "no return valve" incorporated

this can prevent the correct draining of your dishwasher.

We advise you therefore to remove it.

Electrical connection

Information concerning the electrical connection is given on the

rating plate on the edge of the dishwasher's door.

Before plugging the appliance into the wall socket, make sure

that:

1. The mains voltage and current rating at the site of

installation match the nominal voltage and current rating

given on the rating plate.

2. The meter, fuses, mains power supply and wall socket can

all take the maximum load required. Make sure that the

socket and plug are compatible without having to use any

type of adaptor. If necessary, have the domestic wiring

system socket replaced.

To isolate the dishwasher from mains, remove the mains plug.

Important!

The plug must still be accessible after the appliance

has been installed.

In case that the electrical cable has to be replaced,

please contact your local Service Force Centre.

The appliance should not be connected to the

electrical supply by means of an extension cable.

Safety standards require the appliance to be

earthed.

The manufacture accepts no liability for failure to

observe the above safety precautions.