Zanussi ZTI 6100 Книга инструкций - Страница 25
Просмотреть онлайн или скачать pdf Книга инструкций для Посудомоечная машина Zanussi ZTI 6100. Zanussi ZTI 6100 27 страниц.
Печатать страницуThe furniture door
The door on this appliance is designed for the overlay
of a panel having the following dimensions:
Width
596 mm
Height
644 - 724 mm max
Thickness
20 mm max
Weight
2 - 7.5 kg max
The height of the panel depends on the height of
adjacent kitchen units (see kitchen plinth adjustment).
The panel height should be no more than
indicated, otherwise complete opening of
the door will not be possible as the furniture
door panel will hit against the dishwasher
plinth.
Mounting the furniture door onto
the door
The panel must be fitted with a handle, as the
dishwasher handle will be hidden by the panel.
1. Drill the panel with a Ø 2 x 14 bit according to the
dimensions given in the picture.
2. Screw the two fastening pivots in the holes
indicated in the picture.
3. Mount the decor panel by inserting the two
fastening pivots into the slotted holes of the door.
Lift the decor panel until perfect alignment with the
fascia panel is obtained.
4. Once the correct position has been found, open the
door and fasten the decor panel by means of the
six or eight 4 x 40 screws provided, using the holes
through the inner door.
Fixing to the adjacent units
To prevent the dishwasher tilting, it must be secured to
either the worktop or adjacent kitchen cabinet/wall
using the brackets supplied.
Insert the two fixing brackets into the slots provided in
the top front part of the dishwasher as shown in the
figure.
Secure the brackets to the adjacent units with the
3.5 x 16 screws using the upper or the side holes.
The appliance must be secured to the underside of
the worktop using the brackets provided. Failure
to do this could cause damage or injury.
Attention!
The sides of the dishwasher must never be
drilled to prevent damage to hydraulic
components.
596 max
596 max
553
525
=
II92
II112
II116
II117
II54
50
=
INS14/1en