Zanussi ZGF 648 IX Руководство пользователя - Страница 7

Просмотреть онлайн или скачать pdf Руководство пользователя для Варочная панель Zanussi ZGF 648 IX. Zanussi ZGF 648 IX 44 страницы.

Operation

Hob burner control knobs

The symbols on the knobs mean:

= no gas supply

= maximum gas supply

= minimum gas supply

For easier lighting, proceed before

putting a pan on the pan support.

Lighting the burners

Push the relevant knob down and

turn it anti-clockwise until it reaches

the "maximum" position.

Only for mod. ZGF 646 CT / ZGF

646 IT / ZGF 648 IR / ZGF 643 ITXC

After lighting the flame, keep the

knob pushed down for about 5

seconds.

This

"thermocouple" (see figure - lett. D) to be

heated and the safety device to be

switched off, otherwise the gas supply

would be interrupted.

Then, check the flame is regular and

adjust it as required.

If you cannot light the flame even after

several attempts, check the "cap" and

"crown" (see figure - lett. A, B) are in the

correct position.

When switching on the mains, after

installation or a power cut, it is quite

normal for the spark generator to be

activated automatically.

In the absence of electricity, igni-

tion can occur without the

electrical device; in this case

approach the burner with a flame,

push the relevant knob down and

turn it anti-clockwise until it

reaches the "maximum" position.

will

allow

the

A - Burner cap

B - Burner crown

C - Ignition candle

D - Thermocouple