Zanussi ZGS 646X Буклет с инструкциями - Страница 8
Просмотреть онлайн или скачать pdf Буклет с инструкциями для Варочная панель Zanussi ZGS 646X. Zanussi ZGS 646X 16 страниц.
Печатать страницу
Adaptation to different types of gas
Injectors replacement
• Remove the pan supports.
• Remove the burner's caps and crowns.
• With a socket spanner 7 unscrew and remove the
injectors (Fig. 5), and replace them with the ones
required for the type of gas in use (see table 2).
• Reassemble the parts, following the same procedu-
re backwards.
• Replace the rating label (placed near the gas supply
pipe) with the relevant one for the new type of gas
supply. You can find this label in the package of the
injectors supplied with the appliance.
Should the feeding gas pressure be different or variable
compared with the required pressure, an appropriate
pressure adjuster must be fitted on the gas supply pipe,
in compliance with the rules in force.
Adjustment of minimum level
To adjust the minimum level of the burners, proceed as
follows:
•
Light the burner.
•
Turn the knob on the minimum position.
•
Remove the knob.
•
With a thin screwdriver, adjust the by-pass screw
positioned in the centre of the gas tap control shaft
(see Fig. 6). If changing from natural gas 20 mbar to
liquid gas, completely tighten the adjustment screw
in. If changing from liquid gas to natural gas 20 mbar,
undo the by-pass screw about 1/4 of a turn. If changing
from natural gas 20 mbar to natural gas 13 mbar undo
the by-pass screw about 1/4 of a turn. If changing from
liquid gas to natural gas 13 mbar, undo the by-pass
screw about 3/4 of a turn.
•
Finally check the flame does not go out when quickly
turning the knob from the maximum position to the
minimum position.
This procedure can easily be carried out, anyhow the hob
has been positioned or built in the working top.
Table 2 : injectors
TYPE
TYPE OF
OF GAS
BURNER
NATURAL
Rapid (large)
GAS
Semi-rapid (medium)
G 20
Auxiliary (small)
LPG
Rapid (large)
(Buthane/
Semi-rapid (medium)
Propane)
Auxiliary (small)
NATURAL
Rapid (large)
GAS
Semi-rapid (medium)
G 20
Auxiliary (small)
8
INJECTORS
NOMINAL
MARKS
POWER
1/100 mm
INPUT
K W
-
113
2,80
96
2,00
70
1,00
86
2,80
71
2,00
50
1,00
108
2,13
105
1,72
80
0,90
Fig. 5
Fig. 6
By-pass screws
Table 1 : By-pass diameters
Burner
Rapid
Semi-rapid
Auxiliary
REDUCED
POWER
k W
m
0,75
0,267
0,45
0,190
0,33
0,095
0,75
0,45
0,33
0,52
0,210
0,42
0,186
0,30
0,085
Ø By-pass
in 1/100
of mm.
42
32
28
NOMINAL
NOMINAL
POWER
PRESSURE
mbar
3
/h
g/h
-
-
20
-
-
204
-
145
30
-
73
-
-
13*
-
* for Russia only.