Zanussi ZCUF99W Буклет с инструкциями - Страница 9
Просмотреть онлайн или скачать pdf Буклет с инструкциями для Морозильная камера Zanussi ZCUF99W. Zanussi ZCUF99W 14 страниц. Freezer zcuf99w
Печатать страницуTo Change the Light Bulb
The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
To replace the lamp in the chiller compartment (only
cabinets with two doors), first unscrew the lamp
grille with a screwdriver.
Use a bulb of the same type, E14 socket, maximum
rating of 25 W.
When the appliance is not in use
Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
Something Not Working
Before contacting your local Service Force Centre check the following points:
Symptom
The temperature is too high inside the
freezer.
The temperature is too low inside the
freezer.
Too much frost and ice are produced.
The compressor operates continuously.
The cabinet does not operate at all.
Cooling or interior light does not
operate. No indicator lamps light.
Noise
Power failure
If the appliance is left on, e.g. while on holiday, ask
somebody to check it once in a while to prevent the
food inside from spoiling in case of a power failure.
Set a lower temperature.
Make sure that the door is completely closed and that the
rubber door seal is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
Set a warmer temperature.
Fast Freeze could have been switched on.
Make sure that the door is completely closed and that the
rubber door seal is complete and clean.
Set a warmer temperature.
Make sure that the door is completely closed and that the
rubber door seal is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
The appliance is not switched on.
Power does not reach the appliance. (Try connecting another
electrical device to the power outlet.)
The fuse has blown.
The power plug is not properly connected.
See "Normal operating Sounds" in chapter
Hints and Tips.
Make sure the pipes at the back of the cabinet not touch each
other. Carefully bend them if they do.
If the cushion spacers (between the cabinet wall and pipes)
come loose, put them back in place again.
Carefully follow the instructions in the chapter "Installing the
cabinet".
Do not unnecessarily open the cabinet, except when the power
cut seems to be long, in which case the food products should be
moved to another cabinet that works. See the chapter "Hints
and Tips".
9
Solution
Zanussi 818 20 91-00/2