Zanussi zft 710 w Руководство пользователя - Страница 40

Просмотреть онлайн или скачать pdf Руководство пользователя для Морозильная камера Zanussi zft 710 w. Zanussi zft 710 w 48 страниц.

Печатать страницу

Putting it into use

Put the plug into the mains socket. Turn the thermo-

static control knob according to the figure. This time

the red lamp starts giving light, the compressor starts

and cooling begins shortly.

When the red light goes out the temperature is suffi-

cient and the appliance is suitable for storing frozen

and deep-frozen foods.

Controlling the temperature

The thermostatic controller interrupts the operation of

the appliance automatically for more or less time

depending on the setting then restarts it assuring the

required temperature.

Setting the thermostat knob can be done practically

with a coin. Turning the control knob clockwise cooling

becomes more and more intensive.

In the appliance -18 °C or lower temperature can be

reached if the thermostat knob is set according to the

figure.

The thermostat can be switched off („0" position),

which means breaking the circuit of the compressor

i.e. stopping cooling.

The temperature coming about in the freezer is effect-

ed by not only the position of the thermostatic control

and the ambient temperature, but frequency of door

openings and the quantity of food put into it, etc.

In maximum position of the thermostat - in

case of increased demand e.g. during heat-

waves - the compressor may operate continually. This

does not cause damages to the appliance.

Freezing

Freezing different products should always be done in

the freezing compartment after proper preparation.

Move frozen food from the top drawer into the other

two drawers. For maximum freezing performance

remove the top drawer and then place the foods to be

frozen directly on the evaporator. In case of freezing

smaller food volumes you do not need to remove the

drawer.

Switch on the freezer switch (pops up and lights by

pressing) 4 hours before freezing food of small quan-

tities and about 24 hours before freezing products of

larger quantities. This time the compressor operates

continuously to reach the temperature necessary for

freezing.

Place in the foods to be frozen and let the appliance

operate for about 24 hours as written above.

Then push the fast freezer switch again (the yellow

light will go out and the switch turns to its original posi-

tion).

Move the fresh frozen food into the top drawer and

insert the drawer in the appliance in its working posi-

tion.

Storing

It is practical to replace frozen products into the stor-

ing compartments after freezing has finished so that to

make room in the freezing compartment for another

freezing.

In large quantities of food are to be stored, remove the

baskets except the lowermost one from appliance and

place food on the shelves.

Intermediate freezing does not deteriorate foods

already stored.