Zanussi ZHC 955 Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Вентиляционная вытяжка Zanussi ZHC 955. Zanussi ZHC 955 16 страниц. Zanussi owners manual ventilation hood zhc 955
Также для Zanussi ZHC 955: Инструкции по эксплуатации и установке (16 страниц)
Печатать страницу
Charcoal filter
• The charcoal filter should only be used if you
want to use the hood in recirculation mode.
• To do this you will need an original charcoal
filter (available from your local Service Force
Centre).
• Cleaning/replacing the charcoal filter
Unlike other charcoal filters, the LONGLIFE
charcoal filter can be cleaned and reactivated.
With normal use the filter should be cleaned
every second month (when using the hood 2,5
hours per day,on avarage). The best way to
clean the filter is in the dishwasher. Use normal
detergent and choose the highest tempera-
ture (65º C). Wash the filter separately so
that no food particles get stuck on the filter
and later causes bad odours. To reactivate
the charcoal, the filter should be dried in
an oven for 10 minutes with a maximum
temperature of 100º C.
After approximately three years of use, the
charcoal filter should be replaced with a new, as
the odour reduction capacity will be reduced.
• Fitting
Remove the frame i which supports the filter h
by turning 90° the two knobs g.
Insert the charcoal filter inside the frame and
put all parts back in their place. Fig. 4.
• To remove proceed in the reverse order.
• Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the rating
plate located on the inside of the unit.
• The charcoal filter can be ordered from your
local Service Force Centre.
Changing the light bulb
• Disconnect the cooker hood from the mains
electricity supply.
• Extract the lamp, the lamp support and its
connector A, carefully use a flat bladed
screwdriver as a lever. Fig. 5.
• Replace the old bulb with a new one of the
same type.
• If the light does not come on, make sure the
bulb has been inserted correctly before
contacting your local Service Force Centre.
Fig. 4
Fig. 5
7