Zanussi ZCG62256 Руководство пользователя - Страница 23
Просмотреть онлайн или скачать pdf Руководство пользователя для Плиты Zanussi ZCG62256. Zanussi ZCG62256 28 страниц.
Печатать страницу
In installation always use the pipe holder and
the gasket. The flexible pipe can be applied
when:
• it can not get hotter than room temperature,
higher than 30 °C,
• it is not longer than 1500 mm,
• it has no narrowing anywhere,
• it is not twisted or tighten,
• it does not get in touch with sharp edges or
corners,
• it's conditions can be easily checked.
When checking the flexible pipe make sure:
• it does not show cracks, cuts, marks of
burnings on the two ends and on its full
length,
• the material is not hardened, but shows its
correct elasticity,
• the fastening clamps are not rusted,
• expired term is not due.
If one or more defects are visible, do not repair
the pipe, but replace it.
WARNING!
When installation is complete, make
sure that the seal of each pipe fitting
does not leak. To check the seal use
a soap solution, not a flame.
The gas supply ramp is on the rear side of the
control panel.
WARNING!
Before you connect the gas,
disconnect the appliance from the
electricity supply or switch off the
fuse in the fuse box. Close the
primary valve of the gas supply.
Adjustment to different types of gas
WARNING!
Let only an authorized person do the
adjustment to different types of gas.
Check the table in chapter "Product
descriptions" to see the initial gas of
your appliance.
If the appliance is set for natural gas
you can change it to liquid gas, with
the correct injectors.
If the appliance is set for liquid gas
you can change it to natural gas,
with the correct injectors.
The gas rate is adjusted to suit.
www.zanussi.com
WARNING!
Before you replace the injectors,
make sure that the gas knobs are in
the Off position. Disconnect the
appliance from the electrical supply.
Let the appliance cool down. There
is a risk of injury.
The appliance is set to default gas.
To change the setting choose a pipe
holder from the list. Always use the
gasket sealing.
A
A. Gas connection end
B. Natural Gas pipe holder
C. LPG pipe holder
Hob injectors replacement
Replace the injectors when you change the gas
type.
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. Remove the injectors with a socket spanner
7.
4. Replace injectors with the ones necessary
for the type of gas you use.
5. Replace the rating plate (it is near the gas
supply pipe) with the one for the new type
of gas supply.
You can find this plate in the
bag supplied with the appliance.
If the supply gas pressure is not constant or it is
different from the necessary pressure, install an
applicable pressure adjuster on the gas supply
pipe.
B
C
23