ACOPOWER LiONCooler X30A Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Холодильник ACOPOWER LiONCooler X30A. ACOPOWER LiONCooler X30A 16 страниц. 30/40/50l rechargeable fridge freezer
Также для ACOPOWER LiONCooler X30A: Краткое руководство по эксплуатации (8 страниц)
Печатать страницу
•
Temperature Setting: Can be adjusted by the "+" button up to 20℃ (Max) and
down to -20℃ (Max) by the "- "button; Default temperature is Celsius degree (C).
If you would like to change to Fahrenheit degree (F), turn off the fridge, press and
hold SET button over 3 seconds. E1 should display on screen and begin flashing;
continue to press SET button until E5 shows up, then press △ or ▽, select
desired units: F or C.
The compressor will cool down the temperature from 10℃ to -10 ℃ in 20 mins.
However, this reflects the change in temperature within the insulated walls of the
fridge/freezer. Allow an additional hour or more time, depending on the food load,
to reach cooling temperature around 1-6 degrees Celsius. To reach freezing with
food or beverage inside it will take approximately 8 hours. Therefore, if you want
frozen or chilling temperatures inside, we suggest you turn on the compressor 10
hours ahead of time while keeping the temperature setting at -15℃ or lower.
Cooling Mode Control: Press the button "
•
will switch between MAX (Quick cooling mode) and ECO (Energy-saving mode)
(tip: Max mode is recommended to begin initial cool down). After desired
temperature has been attained, it is recommended to switch to ECO mode to
conserve energy cooling mode.
•
Battery Protection: Selecting the H, M, L positions, you can choose different levels
for car battery protection. When the unit is on and working, press the "
button over 3 seconds, then the LCD will display as below:
o L: Low power protection 9.6V (factory default)
o M: Middle power 10.8V
o H: High power protection 11.3 V
When the unit is connected to the car, we suggest setting the car battery
protection to H level. L is suggested when the unit is powered with freezer battery
or other outside backup battery.
•
USB Output: +5VDC /2.1A for cell phone, tablet, WIFI speaker, etc.
Note: Don't change setting on E1-E4 which is only for factory maintenance.
" to select control mode. Short Press
3
"