Blackberry Radar H2 Руководство по установке - Страница 12

Просмотреть онлайн или скачать pdf Руководство по установке для Радар Blackberry Radar H2. Blackberry Radar H2 30 страниц. Dry van, insulated trailers roll-up doors
Также для Blackberry Radar H2: Руководство по установке (33 страниц), Руководство по установке (26 страниц), Руководство по установке (25 страниц), Руководство по установке (32 страниц), Руководство по установке (33 страниц), Руководство по установке (34 страниц), Руководство по установке (35 страниц), Руководство по эксплуатации (33 страниц), Руководство по установке (32 страниц), Руководство по установке (26 страниц), Руководство по установке (25 страниц), Руководство по установке (28 страниц)

Печатать страницу
Blackberry Radar H2 Руководство по установке
12
BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE
To attach the module to the asset you wish to track, you will need to supply your own
fasteners. Depending on the construction of your mounting location, you may wish to use
the following types of fasteners. Please Note: Your choice of fastener will influence the size
of the tools required to create the mounting holes (i.e. drill bits) and install or remove the
fasteners (i.e. wrenches/sockets/drivers). An example of this provided below. The actual
length of the fasteners will be determined by the thickness of your mounting surface.
IMPORTANT: The maximum fastener thread
diameter supported by this product is ¼" or
M6 (6 mm).
For most secure fastening, we do not
recommend using fasteners with a diameter
less than that of a ¼" or M6 fastener.
•
Box Section
(+3mm wall thickness)
I-Beam / Panel Section
(with rear access)
•
Panel doors
(plywood/MDF/foam cores)
Cargo Van Doors
(with no rear access)
2 self-tapping screws and washers
(3/8" head, 1/4"-14 thread, 1-1/4" length)
2 bolts, nuts, and 4 washers
(7/16" head, 1/4"-20 thread, 1/4"-20 nut)
(11mm head, M6 thread, 25mm length, M6 nut)
2 bolts, nuts, and 4 washers
1/2"
(7/16" head, 1/4"-20 thread, 2
nut)
(11mm head, M6 thread, 57-100mm length, M6 nut)
2 bolts, washers, and well nuts
Bolt: 7/16" head, 1/4"-20 thread, 1-1/2" length
Insert: 1/4"-20 thread
Drill Bit
Nut Driver/Socket/Wrench
Drill Bit
Nut Driver/Socket/Wrench
Drill Bit
-4" length, 1/4"-20
Nut Driver/Socket/Wrench
Drill Bit
Nut Driver/Socket/Wrench
3/16" (5mm)
1/4" (6mm)
1/4" (6mm)
1/2" (13mm)