Clarke 3120193 Инструкции по эксплуатации и техническому обслуживанию - Страница 11
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Сандер Clarke 3120193. Clarke 3120193 17 страниц. Multi-sander kit
Печатать страницу
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air released.
2. Refer to the compressor instruction manual for the procedure to shut down
and release the compressed air.
3. Once the pressure has been released, disconnect the air supply hose from
the air tool.
MAINTENANCE
WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE
PROCEDURES.
DAILY
1. Before use, drain water from the air tank, air line and compressor.
2. Pour a few drops of CLARKE airline oil into the air inlet. This should be carried
out regardless of whether or not an in-line mini oiler is used. If an in-line
lubricator is not used, this procedure should be repeated after every two to
three hours of use.
WEEKLY
1. Check the air inlet strainer for
blockage and clean if necessary.
CLEANING
1. Keep the body of each tool clean
and free from debris.
2. Grit or gum deposits inside the tool
may also reduce its efficiency. This
condition can be corrected by
cleaning out the air strainer and
flushing out the tool with gum solvent or oil, or failing this, the motor may
require dismantling. This is better left to your Clarke dealer.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11