Clarke American Sanders 07098A Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сандер Clarke American Sanders 07098A. Clarke American Sanders 07098A 17 страниц.

Печатать страницу

1. Parts and Service Manual - Section

MACHINE SET-UP

1. Familiarize yourself with the machine. Read all danger,

warning, and caution statements and the Owner's Manual

before operating this machine. If you or your operator

cannot read English, have this manual explained fully

before attempting to operate this machine.

2. Install dust bag support to the exhaust bracket (figure 1).

Place opening of dust bag over dust bag support and

exhaust bracket; cinch and tie securely to exhaust bracket.

3. Remove screw and abrasive retainer. Center abrasive on

pad and secure with abrasive retainer and screw. (Figure

4. Return machine to upright position and tilt machine back on

casters until it comes to rest on the exhaust bracket.

Machine will be in a reclined position. Do not allow ma-

chine to rest on pad especially after use, or compression

set may take place within elastomer on pad. This will

create a flat spot and bounce during use. (Figure 3)

OPERATING INSTRUCTIONS

1. Move machine to the location of your work. Set any

exposed nails with hammer and punch to avoid encounter

with abrasive.

WARNING:

Bodily injury could occur if power is applied to the

machine with the power switch already in the "ON"

position. Always check to assure that the power

switch is in the "OFF" position before applying

power to the power cable.

2. Make sure the control switch is in the "Off" position then

connect the supply cable to an appropriately grounded

fused circuit. Connect the supply cable to the motor pigtail.

(Figure 4)

3. With the machine in the reclined position firmly grasp both

handles and flip the control switch to the "ON" position.

(Figure 3.)

Gradually lower pad to surface intended for sanding.

Make sure the machine is in motion while the pad is

engaged with the surface to be sanded. You may use

broad circular motion as you sand along the length of

the surface or your may use a combination of forward

and sideward motions. In time you will develop your

own technique to optimize coverage and dust recovery. It

is advisable to not add effort to the pad as this may lead

to "nosing in" or "tipping" which produces grooves or

lines on the surface.

When replacing abrasive, emptying the contents of the

dust bag, or sanding operation is completed, return

machine to reclined position, flip control switch to "Off"

then disconnect the motor pigtail from the supply cable.

Empty dust bag whenever it becomes 1/3 full.

Clarke

American Sanders Super 7R Operator's Manual

Figure 1

Figure 2

Figure 3

Figure 4

Page 7