Clarke American Sanders B2 Руководство по эксплуатации - Страница 9
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сандер Clarke American Sanders B2. Clarke American Sanders B2 20 страниц. 7" spinner edger ce
Печатать страницу
revised 3/13
SANDING CUTS AND SANDPAPER
Initial Cut
The purpose of the initial cut is to remove old fi nish and gross imperfections on the fl oor surface. A coarse
abrasive should be used. If the surface is severely damaged by deep scratches, pre-existing dwell marks,
uneven planks, etc., it may be necessary to sand across or diagonally to the grain to restore evenness to the
surface. If these conditions are not present, the initial cut should be done in the direction of the grain.
If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this
should occur during an initial cut, the abrasive has dulled and must be replaced.
Final Cuts
The purpose of a fi nishing cut is to remove the scratches produced during the initial cut. Use a fi ne (60 - 80
grit) grain abrasive.
If the surface remains rough after a fi nishing cut, it may be necessary to use an even fi ner grain of abrasive
(80 - 100 grit). Care should be taken in selecting the grit size of the abrasive. A very fi ne grain will close
the pores on a wood fl oor making admission of a stain diffi cult.
If glazing or burning should occur immediately into a fi nishing cut, increase pace. If it should occur during a
fi nishing cut, the abrasive has dulled and must be replaced.
American Sanders B-2 (CE) Operator's Manual
FORM NO. 70162B - 9 -
Clarke
®