Clarke CROS1 Руководство по эксплуатации и техническому обслуживанию - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Сандер Clarke CROS1. Clarke CROS1 13 страниц. Rotary orbital sander
Также для Clarke CROS1: Инструкции по эксплуатации и техническому обслуживанию (12 страниц)

MAINTENANCE

Always inspect the sander before use and ensure it is in top condition.

Ensure all air vents are clear. (Use compressed air to clean the machine where

possible).

Check the power cable to ensure it is sound and free from cracks, bare wires

etc. Avoid using solvents when cleaning plastic parts, (most plastics are

susceptible to damage from the various types of commercial solvents).

All bearings etc., in this tool are lubricated with sufficient high grade lubricant

for the machine's lifetime under normal operating conditions, therefore no

further lubrication is required.

SANDER IS OVERHEATING

Overheating indicates the machine is blocked with dust. Clean the ventilation

holes, and blow out with compressed air. Wipe the exterior with a dry cloth.

Overloading the machine will also cause overheating. Do not use for heavy

duty work and do not apply excessive pressure.

EXCESSIVE SPARKING

This indicates worn brushes. This problem is easily remedied but you should

consult your CLARKE dealer for parts and advice.

SANDER DOES NOT OPERATE WHEN SWITCHED ON

Check to ensure the fuse in the plug is sound and replace if necessary. If the

fuse is sound or blows repeatedly, consult your CLARKE dealer.

DUST IS NOT EXTRACTED

The dust bag is full or the dust extractor flue is blocked, This is usually caused by

allowing the bag to become too full. Remove and empty the bag, also clear

any blockage.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]