Clarke CWP200 Руководство по эксплуатации и техническому обслуживанию - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Водяной насос Clarke CWP200. Clarke CWP200 13 страниц. Submersible clean water pump

Печатать страницу

POSITIONING THE PUMP

1. Stand the pump upright on a flat surface in the pool that you want to

drain.

2. If there is sediment in the pool or pond, place the pump on blocks, to avoid

blocking the water inlet.

3. Ensure the pump is positioned with adequate space - recommended

minimum base area of 460 x 460 cm and the maximum depth of any

installation - 5.5 metres. The pump is fitted with 10 metres of power cable.

4. Always raise and lower the pump using the lifting handle and a rope

attached to it if required. Never lift or lower the pump using the power

cable.

• The water inlet must be fully submerged before the pump is switched on

and the pump standing upright.

5. Connect the power cable to a high sensitivity residual current device

(RCD) which has a tripping current of less then 30mA.

OPERATING THE PUMP

CAUTION: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE

PUMP IF IT IS DAMAGED IN ANY WAY

CAUTION: DO NOT ALLOW THE PUMP TO RUN DRY

1. Switch the mains power supply on.

• The pump will begin to drain water.

2. When pumping is finished, disconnect the pump from the power supply.

• The pump is fitted with a thermal overload switch. If the pump overheats

for any reason, it will automatically switch the pump OFF. Once the

pump has cooled (at least 5-10 minutes), it will automatically restart.

AFTER USE

When the temperature is expected to be lower than 0°C, ensure there is no

water residue which could freeze and damage the pump.

If the pump has been used with substances that tend to form a deposit, or

with water containing chlorine, rinse it after use with a powerful jet of water in

order to avoid the formation of deposits or encrustations which would reduce

the characteristics of the pump.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]