Clarke DWP300A Руководство по эксплуатации и техническому обслуживанию - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Водяной насос Clarke DWP300A. Clarke DWP300A 13 страниц. Submersible pump
Печатать страницу
POSITIONING THE PUMP
1. Stand the pump upright on a flat
surface in the pool that you want
to drain. If there is sediment in the
pool or pond, place the pump on
blocks, to avoid blocking the
water inlet.
2. Set the height of the pump inlet
by extending and twisting the
base (foot) if required. With the
base retracted the pump can
remove all but the remaining 10
mm of water. With the base extended the pump can pick up more solids in
suspension.
3. Ensure the pump is positioned with adequate space - recommended
minimum base area of 20 x 25 cm and the maximum depth of any
installation - 5.5mtr. The pump is supplied with 10 metres of power cable.
4. Always raise and lower the pump using the lifting handle and a rope
attached to it if required. Never lift or lower the pump using the power
cable.
• The water inlet must be fully submerged before the pump is switched on
and the pump be standing upright.
5. Connect the power cable to a high sensitivity residual current device
(RCD) which has a tripping current of less then 30mA.
OPERATING THE PUMP
WARNING: CHECK THE PUMP FOR DAMAGE BEFORE USE, DO NOT USE THE
PUMP IF IT IS DAMAGED IN ANY WAY.
1. Switch the mains power supply on.
• The pump will begin to drain water.
• As the water level falls, so will the float switch, until it stops the pump.
• You can set the position of the float switch using the clip on the side of
the pump. Adjusting the length of the float switch lead will change the
depth of water at which the pump will turn on or off.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7