Alemite 586-B Инструкции по эксплуатации и техническому обслуживанию - Страница 10
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Инструменты Alemite 586-B. Alemite 586-B 16 страниц. Cordless grease gun (battery charger included)
Также для Alemite 586-B: Инструкции по эксплуатации и техническому обслуживанию (12 страниц)
Печатать страницу
Prime gun
In most cases the gun will prime simply by
operating the trigger several times.
Should grease fail to appear, air must be
bled.
Force prime
This process manually assists air within the
gun to be bled at the bleed valve.
1 Pull follower rod and engage follower by
rotating rod.
2 Depress bleed valve (45) and at same time
push on follower rod.
Once the air is eliminated, operate the gun
several times.
Once grease appears, disengage the
follower rod from the follower and push into
the grease cylinder.
Check valve contamination
Should the gun fail to prime; the outlet check
may be held open. Remove plug (36), clean
ball (38), and the ball seat of head (14).
NOTE
Gun is equipped with software to protect
motor. When a blocked bearing, line, or
grease fitting causes gun to stall,
software will cut power to motor.
If this situation occurs, release trigger
immediately.
For maximum motor life, avoid
operating at stall.
Battery and charger safety
This manual contains important safety and
operating instructions for battery part
number 343432 and battery chargers
343500 and 343501.
Battery (41) is intentionally shipped with a
low charge. Charge battery prior to use.
Refer to battery charger operation section
for details.
WARNING
Before using battery charger read all
instructions and cautionary markings
on battery charger (42, 43), battery (41),
and products using battery.
Do not use extension cord.
Do not incinerate battery, even if it is
severely damaged or completely worn
out. Battery may explode in fire.
Risk of electric shock 120 V AC or
230 V AC present at charfer terminals.
Do not expose battery to spark or
flame. Battery liquid may burn.
Do not splash or immerse in water or
other liquids. This may cause premature
cell failure.
Never attempt to open battery pack
for any reason. If plastic bag of battery
pack breaks or cracks, return to a ser-
vice center for recycling.
Failure to comply may result in death
or serious injury.
10
CAUTION
Do not expose charger to rain, snow,
or frost.
Make sure cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or
stress.
Do not operate charger with damaged
cord or plug. Replace immediately.
Do not operate charger if it has
received a sharp blow, been dropped, or
otherwise damaged in any way.
Do not disassemble charger.
Charger is designed to operate on
standard household electrical power.
Do not attempt to use it with any other
voltage.
Consecutive charging may cause
overheating. If you need to recharge
battery consecutively, wait for
15 minutes to allow charger to cool.
Do not insert foreign material into slot
for battery in charger stand.
Do not disassemble battery.
Do not store gun and battery assem-
bly in locations where temperature may
reach or exceed 104° F (40° C).
Do not short-circuit battery.
Do not place charger in an area of
extreme heat or cold. It works best at
normal room temperature.