Alemite 7234-B Руководство по эксплуатации - Страница 12
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Инструменты Alemite 7234-B. Alemite 7234-B 12 страниц. Heavy-duty hose reels
Печатать страницуSER 7234-B
Reel Operation
Reel Lockup
Caution
Do not remove the hose completely from the reel
to rapidly. Too much force can cause the reel to
over-run, latch, and lockup. If this occurs, the reel
cannot be extended to release the latch mecha-
nism.
Should the reel lockup, it will be necessary to have an
assistant maintain tension on the hose while the latching
mechanism is manually released.
Indications
Reel does not latch
Reel does not retract
Reel retracts partially
Reel does not unlatch
after maximum length
of hose is removed
Material leakage at the
Swivel Assembly
Material leakage at
Union Adapter (A)
* The possible causes for broken components are listed in italics
Revision (7-97)
Troubleshooting Chart
Possible Problems
Spring (35) broken or not attached to Latch Pawl (32)
1. Spring Arbor (21 / 22) broken* or installed incorrectly
2. Power Spring (41) broken* or installed incorrectly
3. Reel installed over 16 ' (4.9 m)
4. Hose length greater than 50 ' (15.2 m)
Improper Power Spring (41) tension
1. Power Spring (41) wound solid
2. Hose removed from the reel too quickly
1. Connection not sufficiently tight
2. Worn or damaged Swivel Assembly
1. Connection not sufficiently tight
2. Worn or damaged Union Adapter (A)
Changes Since Last Printing
Added Medium-Pressure Swivel Assembly 393539-99
WARNING
The reel is under maximum Spring tension.
Personal injury can occur.
1. Grip the Sheave Assembly securely with gloved hands.
2. Turn the Sheave Assembly in the direction just enough
that allows Latch Pawl Assembly (32) to be free of
tension from the Ratchet.
• This direction further increases tension on the Power
Spring.
3. While maintaining the position of the Sheave assembly
with one hand, move the Latch Pawl Assembly away
from the Ratchet Assembly.
• Use a screwdriver or other suitable tool.
4. Instruct the assistant to allow the hose to retract slowly
onto the Sheave Assembly.
12
Heavy-Duty Hose Reels
Solution
Replace or secure Spring (35)
1 and 2. Replace or orientate
components properly.
3. Install reel at 16 ' (4.9 m)
4. Install a hose not to exceed 50 '
(15.2 m) in length
Set tension properly
1. Decrease Spring (41) pre-wind
2. Remove hose slowly when close
to being fully extended
1. Tighten material hose to Swivel
and Swivel to Main Shaft (24)
2. Repair or replace Swivel
1. Tighten material hose to Adapter
and Adapter to Main Shaft (24)
2. Replace Adapter
Alemite Corporation