Alemite 7344 Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Инструменты Alemite 7344. Alemite 7344 8 страниц. High capacity twin hose reel
Печатать страницу
SER 7343
Indications
Reel does not latch
Pawl Spring (29) broken or not attached to Pawl and
Shaft Assembly (28)
Reel does not retract
Power spring broken*
Reel retracts partially
1. Improper power spring tension
2. Hose length greater than recommendation
Reel does not unlatch
1. Power spring wound solid
after maximum length
2. Hose removed from the reel too quickly
of hose is removed
(Reel Over-Run)
Material leakage at
1. Connection not sufficiently tight and / or thread
Swivel Assembly (2)
sealant missing at Bushing (1)
2. Worn or damaged O-Rings (2c)
3. Worn or damaged O-Ring (2f)
4. Worn or damaged Swivel Stem (2e)
Material leakage from
1. Delivery hose connection not sufficiently tight
delivery hose
2. Thread sealant missing at Unions (22) or Bushings
connections
(1) and / or Unions and / or Bushings not
sufficiently tight into Shaft (19) or Shaft and
Flange Assembly (20)
* The possible causes for broken components are listed in italics
Revision (11-08)
1-800-548-1191-http://[email protected]
Troubleshooting Chart
Possible Problems
Changes Since Last Printing
339389-3 for 8080-K
339389-4 for 8080-L
8
High Capacity Twin Hose Reel
Solution
Replace or secure Pawl Spring (29)
Replace Power Spring Assembly (26)
1. Adjust tension
2. See Table 1.
1. Decrease power spring pre-wind
2. Remove hose slowly when close to being fully
extended
1. Apply sealant to male threads of
Bushing (1) and tighten connections
2. Replace O-Rings (2c)
3. Replace O-Ring (2f) or use Repair Kit 393781
4. Replace Swivel Stem (2e)
1. Tighten connection
2. Apply thread sealant to Unions (22) or Bushings
(1) and tighten into Shaft (19) or Shaft and
Flange Assembly (20)
Alemite, LLC