Directed Electronics 450.5 Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель Directed Electronics 450.5. Directed Electronics 450.5 16 страниц. Directed electronics audio power amplifier owner's manual
Печатать страницу
electronics and the lower your
speaker load, the more heat is
generated. For low impedance
speaker applications or restricted
ventilation installations, an external
cooling fan may be advisable.
9. Battery and ground connections to
the vehicle should be made with
crimped ring terminals of the appro-
priate size (surface area is what
counts); soldering the terminals
after crimping is also recom-
mended.
WIRE CONNECTOR PLUGS
Power and speaker wire connections on
Viper Audio power amplifiers are
performed with the use of specially
designed connectors that allow for ease
of wire termination and installation
convenience.
Poor connections are a common cause
of poor sound quality or amplifier perfor-
mance. Making proper wire connections
is paramount to a reliable, quality sound
system.
Please follow these recommendations to
ensure a problem free installation:
1. Always use the proper gauge wire
for the connector.
2. Cut wires to the minimum length
necessary.
© 2003 Directed Electronics, Inc
10. Due to the high-frequency MOSFET
switching power supply, filtering the
power cable is not generally
required (remember that the amp
can't deliver full output if the power
supply is restricted). Proper
grounding of the signal source is
mandatory for the amplifier to
reach its performance peak. If the
RCA inputs are not grounded
adequately via the signal source,
electrical noise from the vehicle
may be picked up in the system.
3. Trim the wire ends so bare wire
does not protrude from the
connector after termination.
4. Always tighten the connector
screws firmly at least twice, once
during installation and once more
before returning the car to the
customer.
C C A A U U T T I I O O N N : : Over tightening the screws can cause them to strip,
creating loose connections. Tighten the screws
twice firmly for a permanent, solid connection.
N N O O T T E E : :
The speaker connectors are designated on stereo
amplifiers so 1 = Left and 2 = Right. Mono
amplifers are designated so 1 = Speaker 1 and
2 = Speaker 2. For more details regarding mono
applications, please refer to the Speaker Wiring
Diagrams section of this guide.
7