Directed Electronics Xtreme XA-6004 Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Автомобильный усилитель Directed Electronics Xtreme XA-6004. Directed Electronics Xtreme XA-6004 20 страниц. Directed electronics amplifier owner's manual
- 1. Table of Contents
- 2. Congratulations
- 3. Limited Two-Year Consumer Warranty
- 4. Features
- 5. Warning
- 6. Installation Guidelines
- 7. Front Panel Connections/Controls
- 8. REAR Panel Connections-XA-3002/XA-6002
- 9. High Level Harnesses
- 10. Crossover Settings and Gain Adjustment
- 11. CEA Specifications
- 12. Specifications
FRONT PANEL CONNECTIONS/CONTROLS—
XA-3002/XA-6002
N N O O T T E E : : The numbers listed below are referenced on the Input Wiring Diagram.
1. P P W W R R (LED blue) - when illuminated
indicates that the amplifier is on.
2. H H I I I I n n p p u u t t (high level input) - Accepts
1v to 10v input from the headunit's
speaker output. The amplifier will
automatically wake-up when the
input is greater than 1V.
3. R R C C A A I I n n p p u u t t s s - accepts RCA input from a
source unit, preamplifier, or equalizer.
4. L L e e v v e e l l C C o o n n t t r r o o l l - continuously adjusts
from 150mV to 5V for full power
output.
5. C C r r o o s s s s o o v v e e r r S S w w i i t t c c h h - activates low
pass crossover, full (all pass), or
high pass crossover.
6. L L o o w w - - P P a a s s s s F F r r e e q q u u e e n n c c y y C C o o n n t t r r o o l l - adjusts
the frequency (50Hz–500Hz) of
the lowpass crossover.
6
7. H H i i g g h h - - P P a a s s s s F F r r e e q q u u e e n n c c y y C C o o n n t t r r o o l l - adjusts
the frequency (50Hz–500Hz) of
the highpass crossover.
8. B B a a s s s s - sets the bass boost of the
high-pass crossover to 0, 5 or 12dB
of boost.
9. P P R R T T (LED red) - illuminates when
the PRT (Protection) function is
active. Activates to protect the
amplifier when the temperature is
too high, the output has a DC
offset, a short was detected on the
output, or the amplifier power
cables have been improperly
connected (reverse power). If the
temperature, DC offset, or short
condition has cleared after approxi-
mately 10-seconds the amplifier
will automatically recover.
© 2006 Directed Electronics—all rights reserved