CTEK D250S Dual Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Автомобильное зарядное устройство CTEK D250S Dual. CTEK D250S Dual 15 страниц. Dc/dc ic recorder
Также для CTEK D250S Dual: Руководство пользователя (8 страниц), Руководство по эксплуатации (13 страниц), Руководство пользователя (12 страниц)

INSTALLATION OF UNIT

1. Attach the temperature sensor holder on a flat surface on one Service battery. Position it as

close as possible to a positive post.

2. Use the included drill template. Wiring is simplified if the units are installed according to the

drill template, but other setups are possible.

3. Install the unit(s) on a surface where it can be properly fixed and where the unit is not

exposed to fuels, oils or splashes of dirt.

4. Mount the unit with screws intended for the surface and attach it with one screw in each of the

four holes in the corners of the unit. See picture 1. Mount the unit with M4 or ST4.2 screws.

The required torque depends on the surface for mounting. Fig. 1 shows a CTEK D250S. The

same procedure is used for all devices.

5. Attach the cables and mount the cable screws with a torque of 7 Nm. Use tool – hand power

without tools is not enough.

Figure 1

2Nm

INSTALLATION OF CAbLES

Allen key

Figure 2

7Nm

168mm