Directed Video VC2010 Руководство пользователя по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя по установке для ВИДЕОМАГНИТОФОН Directed Video VC2010. Directed Video VC2010 16 страниц. Directed electronics video cassette recorder owner's guide installation guide

Печатать страницу

Rear Panel/TV Connection/AV Power

To connect the VCR and TV, use cable type (A/V RCA-type) appropriate to your TV. Connect the VCR

and TV as shown:

VIDEO OUT - Connects to TV video input.

VIDEO IN - Connects to a second VCR for

recording or video camera for recording.

AUDIO OUT - Connects to receiver or

amplifier input.

AUDIO IN - Connects to a second VCR or

an audio source to record audio.

Audio Output - Additional audio output.

DC (+) 12 VOLT INPUT - To provide power

for the VCR, connect the small plug end of

the power harness on the back of the VCR.

RED:

This wire connects to a circuit

that turns on and off with the key.

YELLOW: This wire connects to the battery

or a constant power source.

BLACK: This wire connects to a good

factory ground wire or a metal

part of the chassis.

REMOTE SENSOR INPUT - The optional

remote infrared (IR) sensor eye allows you

to access all the features on the remote

control when the VCR is mounted in anoth-

er location away from the remote. To install

the remote IR sensor, simply plug it into

the input next to the power plug. Run the

sensor cable to the front of the vehicle and

mount the sensor in a convenient location

so that the remote control can be easily

pointed toward the remote sensor eye.

Note: Route the wires so they can not be pinched, punc-

tured, or chaffed against bare metal. Always fuse

appropriately at the source.