Directed Video MCB1000 Руководство пользователя по установке - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя по установке для Блок управления Directed Video MCB1000. Directed Video MCB1000 16 страниц. Video multi-control unit

Печатать страницу

ANTENNA TV

CATV STD

Installation

INSTALLATION PRECAUTIONS

This product is designed for installation

into vehicles with standard (-) 12 volt

ground electrical systems.

All components should be installed in a

manner that will not interfere with the

normal operation of the vehicle.

Route all wires and cables so they cannot

be pinched, punctured, or chaffed by sharp

metal or screws during reassembly or vehi-

cle operation.

Disconnect the battery's negative terminal

or remove any fuses from circuits that are

affected before the installation.

Components should not be installed on

areas of high moisture, dust, or heat, and

should not be exposed to direct sunlight.

All wiring connections should be made

using solder and tape or quality solderless

connectors. Never leave bare wires. Always

terminate unused wires.

the FM modulator on/off.

NO FM MODULATOR - FM modulator control is defeated.

This FM Modulator function only applies when the

RFM100 is connected.

Select to choose Antenna or Cable input to TVM300.

Select ANTENNA TV when the TVA10 antenna is con-

nected to the TVM300.

Select CATV when using a cable TV connection to

the TVM300.

Choose between three types of cable TV setups.

CATV STD - standard cable system for cable-ready TV's.

CATV HRC - for non-cable ready TV's.

CATV IRC - for non-cable ready TV's.

Before drilling, always check behind panels

for clearance to factory wires, hoses, gas

tanks, or brake lines.

Fuses should only be replaced with like

fuses of the same value. If the replacement

fuse fails, discontinue operation and

contact your authorized retailer.

INSTALLING THE TVM 300

Installing the TVM300 requires working on the

PC board of the MCB1000. Only a MECP Certified

technician should perform this installation.

Disconnect all power wires and cables from

the MCB1000 before beginning this instal-

lation. Failure to do so could result in fire

or damage to the MCB1000 circuitry.

Remove the Philips head screws at both

ends of the MCB1000 module and remove

the cover.

Locate the open rectangular area in the

corner of the PC board. This is the mount-