Clarke DEVIL 370SPD Инструкции по эксплуатации и техническому обслуживанию - Страница 6
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Нагреватель Clarke DEVIL 370SPD. Clarke DEVIL 370SPD 17 страниц. Quartz halogen heater
Печатать страницу
ELECTRICAL CONNECTIONS
WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY
BEFORE CONNECTING THE PRODUCT TO THE POWER SUPPLY.
These 230v heaters are provided with a 13 amp BS 1363 plug, fitted with a 13
amp fuse and MUST be connected to a standard, 230 Volt (50Hz) electrical
supply, preferably through a suitably fused isolator switch.
If the plug has to be changed because it is not suitable for your socket or
because of damage, it must be removed and a replacement fitted, following
the wiring instructions shown below. The old plug must be discarded safely as
insertion into a power socket could cause an electrical hazard.
WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE
COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
BLUE = NEUTRAL
The wires in the mains lead
should be wired up in
accordance with the
following colour code:
• Connect the GREEN &
YELLOW wire to the
plug terminal marked
with a letter E or
• Connect the BROWN
wire to the plug
terminal marked a
letter "L".
• Connect the BLUE wire to the plug terminal marked a letter "N".
The fuse in the plug must be replaced with one of the same rating and this
replacement must be ASTA approved to BS1362.
We strongly recommend that this machine is connected to the mains supply
via a Residual Current Device (RCD).
If in any doubt, consult a qualified electrician. DO NOT attempt any electrical
repairs yourself.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BROWN = LIVE
Plug must be BS1363/A approved.
Earth
(Green and
Yellow)
Neutral
(Blue)
Ensure that the outer sheath of
the cable is firmly held by the clamp
6
YELLOW AND GREEN = EARTH.
Always fit
a 13 Amp
fuse.
Live
(Brown)