Clarke DEVIL 4040 Руководство по эксплуатации и техническому обслуживанию - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и техническому обслуживанию для Нагреватель Clarke DEVIL 4040. Clarke DEVIL 4040 15 страниц. Fan heater

Печатать страницу

ELECTRICAL CONNECTIONS

Devil 4040

This model is provided with a 13 amp BS 1363 plug, fitted with a 13amp fuse and MUST be

connected to a standard, 230 Volt (50Hz) electrical supply, preferably through an ap-

proved plug , or a suitably fused isolator switch.

WARNING! THIS APPLIANCE MUST BE EARTHED

IMPORTANT: The wires in the mains lead are coloured in accordance with the following

code:

Green & Yellow ................................ Earth

Blue .................................................... Neutral

Brown ................................................ Li

As the colours of the flexible lead of this appliance may not correspond with the coloured

markings identifying terminals in your plug, or your mains supply, proceed as follows:

•

Connect GREEN & YELLOW coloured cord to plug terminal marked with a letter "E" or

Earth symbol "

" or coloured GREEN or GREEN & YELLOW.

•

Connect BROWN cord to terminal marked with a letter "L" or coloured RED.

•

Connect BLUE cord to terminal marked with a letter "N" or coloured BLACK.

Fuse Rating

The fuse in the plug must be replaced with one of the same rating (13 amps) and this

replacement must be ASTA approved to BS1362.

This appliance is fitted with a plug which is moulded on to the electric cable (i.e. non-

rewireable) please note:

1. The plug must be thrown away if it is cut from the electric cable. There is a danger of

electric shock if it is subsequently inserted into a socket outlet.

2. Never use the plug without the fuse cover fitted.

3. Should you wish to replace a detachable fuse carrier, ensure that the correct

replacement is used (as indicated by marking or colour code).

4. Replacement fuse covers can be obtained from most DIY or electrical stores.

Devils 4060, 4100 & 4120

These machines MUST be connected to a 400 Volt, 3 PHASE 50Hz supply through a suitably

fused isolator switch. It cannot be operated from a single phase supply.

A trailing socket is NOT provided, but is available from your CLARKE dealer,

Part No:

It is important to note, that the PLUG is wired as shown in the

illustration opposite, as viewed from the outside of the unit - the

socket should be wired correspondingly.

• The GREEN or GREEN & YELLOW coloured wire, is connected to

the terminal marked with the letter "E" or Earth symbol "

• The BLACK or Blue wire is connected to the 'N' or Neutral terminal.

• The Remaining wires are connected to the terminals marked L1, L2 and L3.