LEGO Mindstorms EV3 Руководство пользователя - Страница 31
Просмотреть онлайн или скачать pdf Руководство пользователя для Учебное оборудование LEGO Mindstorms EV3. LEGO Mindstorms EV3 36 страниц.
Также для LEGO Mindstorms EV3: Инструкции (5 страниц)
Печатать страницу
EV3 TECHNOLOGY
EV3 Brick Interface
Set up and run experiment
If you wish to set up and run an experiment, start by clicking
on the Brick Datalog Settings button in the bottom right corner
symbolized by a wrench. Use the Down and Right buttons to navigate
to it and the Center button to click OK.
You can now decide the sample rate of your experiment, ranging
from one sample per minute to a thousand samples per second.
Use the Up and Down buttons to highlight Rate, then use the Left
and Right buttons to select the sample rate you wish to use for
your experiment.
Next, you can choose what sensor to use for your experiment.
Highlight Sensor Setup and click OK with the Center button.
You will now get a list of sensors connected to your EV3 Brick.
Use the Up and Down buttons to highlight the sensor you want to
use. When a sensor is highlighted, use the Left and Right buttons
to select sensor mode (for example, if the Color Sensor should
measure color or ambient light). Once you have found the correct
sensor mode, use the Center button to click OK and you will be
taken back to the Settings screen. On the Settings screen, click
the check mark button and you are now back at the main EV3 Brick
Datalog screen.
To run your experiment, select and click on the Record button (next
to the Settings button with the wrench).
A live graph will now show the incoming values from the selected
sensor. To the right you can see the statistics of your experiment,
including duration. The flashing Record button and pulsing green
EV3 Brick Buttons Light indicate that your experiment is running. To
stop your experiment, click the Center button.
When stopping your experiment, you will be asked to name your
experiment or accept the default name. Once you are done, click
OK and your experiment is now saved in the BrkDL_SAVE folder
that can be accessed from the File Navigation screen (see page 25).
LEGOeducation.com
LEGO, the LEGO logo, MINDSTORMS and the MINDSTORMS logo are trademarks of the/
sont des marques de commerce de/son marcas registradas de LEGO Group. ©2013 The LEGO Group. 041329.
Sample rate
Run experiment
The live graph is not
supported when logging data at
higher rates than ten samples per
seconds. The incoming values
will then only be shown
Sensor setup
NOTE:
as numbers.
31