Clarke 3120152 Инструкции по эксплуатации и техническому обслуживанию - Страница 9
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Инструменты Clarke 3120152. Clarke 3120152 13 страниц. Air hammers
Печатать страницу
MAINTENANCE
WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING, OR MAINTENANCE
PROCEDURES.
DAILY
1. Before use, drain any water from the compressed air supply.
2. This air tool should be lubricated before use. Turn the tool upside down and
pour 1-2 drops of Clarke air-line oil into the air inlet. This should be carried
out regardless of whether or not an in-line mini oiler is used. If an in-line mini
oiler is not used, this procedure should be repeated after every two to
three hours of constant use.
CLEANING
1. Keep all parts of the tool clean.
2. Deposits in the tool may also reduce efficiency. This can be corrected by
cleaning the air inlet and flushing out the tool with gum solvent, or failing
this, the tool should be disassembled, thoroughly cleaned, dried and
reassembled.
3. If the tool becomes inefficient and the air supply is of good quality, it may
be necessary to replace worn or damaged parts. You may prefer to take
the tool to your Clarke dealer if internal maintenance is required.
Your Clarke air tool has been designed to give long and trouble free service. If,
however, having followed the instructions in this booklet carefully, you
encounter problems, take the unit to your local Clarke dealer.
PERFORMANCE
Please note that factors other than the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the airline,
moisture or restrictions in the air-line, or the use of connectors of improper size
or poor condition which will reduce air supply.
**Clarke Air-line Oil (part no. 3050825) is available from your Clarke dealer.
STORAGE
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of
Clarke air-line oil into the air inlet and run the tool in order to lubricate the
internal parts. When not in use, disconnect the tool from the air supply, clean
and store in a safe, dry place.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9