Clarus Fusion Series Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Системы фильтрации воды Clarus Fusion Series. Clarus Fusion Series 20 страниц. Treatment systems
Также для Clarus Fusion Series: Руководство пользователя (20 страниц)

Печатать страницу

Clarus Fusion Series Руководство пользователя

The Fusion

system is designed to continuously operate automatically with little direct maintenance from the owner. Periodically, a check of the

blower area is recommended to ensure no debris obstructs the ventilation or intake areas of the blower. Also, periodically test the control panel

as outlined under the alarm panel section. The owner should closely monitor the types and amounts of substances and products used. Water use

should also be closely monitored to ensure proper operation of the Fusion

Periodically, more extensive maintenance must be performed. Your authorized Fusion

of the maintenance provider can be recorded on the front of this document and should also be located on the alarm panel. For more information

see the Operation and Maintenance section of the manual.

The owner should only perform minimal routine maintenance on the Fusion

and grass clippings). The Fusion

planted in close proximity to the Fusion

Figure 5

HIGH USE WATER DEVICES

The draining of hot tubs and swimming pools into your Fusion

could cause hydraulic overloading and may reduce the treatment

efficiency. Please drain these devices to another location. Contact

your local regulatory authorities or authorized Fusion

provider for more information. The use of large capacity single fill and

drain whirlpool bathtubs may also cause hydraulic overloading of your

Fusion

. Please limit the use of these types of tubs.

FLOODING

If flooding of the Fusion

or the alarm panel is submerged, please disconnect power at the

circuit breaker. DO NOT try to reconnect power to either the blower

or alarm panel once it has been submerged. Immediately contact your

authorized Fusion

maintenance provider to inspect the Fusion

blower, and the alarm panel. Your maintenance provider will repair or

replace the components as needed.

SYSTEM CARE

should also be protected from excessive weight such as vehicular traffic. Trees and bushes should not be

. The Fusion

should be accessible to maintenance personnel and the riser lids must never be buried.

TB2

120 VAC L1

INCOMING N

POWER GND

BLOWER

BLOWER FOR ZF-450 AND ZF-800

system

*FOR ILLUSTRATION PURPOSES ONLY*

REFER TO SCHEMATIC LOCATED IN

maintenance

PANEL FOR INSTALLATION

occurs and the blower

system.

maintenance provider will oversee this service. The name

such as clearing debris from around blower housing (leaves, snow,

1 2 3 4 5 6 7 8

DISNF

ALARM

HIGH WATER

ALARM

It is very important to monitor all water fixtures in the home for leaks

and drips and repair them immediately. Leaks can cause tremendous

water use and use may hydraulically overload your Fusion

reduce its treatment efficiency. Excessive water use may also overload

your soil absorption field and cause failure.

The Fusion

system is designed to function even if wastewater does

not enter it for extended periods of time. The power to the blower

must remain on during this time for the system to function properly.

Weekend use will not harm the system as long as the blower is on.

Should seasonal use require a complete shut down of the property,

then it is recommended that the blower be turned off. It is important

to start up the system in advance of actual occupancy to allow for

, the

normal treatment to resume. Please contact your authorized Fusion

maintenance provider for further information concerning shut down and

startup of the Fusion

. You may also contact your maintenance provider

for the shut down and startup services.

GND LUG

sk2933

LEAKY FIXTURES

INTERMITTENT USE

system and